cifX Communication Interfaces Real-Time Ethernet - Hilscher

Hardware Installation, Deinstallation and Replacement 96/274
5.7.3 Fix Front Plate Sticker at CIFX 100EH-RE\CUBE
Note: Your CIFX 100EH-RE\CUBE Communication Interface set contains
a set of front plate stickers (6 different stickers). Depending from the
loaded firmware the label on each sticker indicates for the respective
system the following LED names:
(1) of the system and communication status LEDs (partial sticker
above)
(2) of the RJ45 Ethernet female connector LEDs (partial sticker below).
Further information to this question you find also in chapter LED
Descriptions beginning from page 200.
Front Plate Stickers (each 2 parts) for CIFX 100EH-RE\CUBE:
Figure 20: Front Plate Stickers for CIFX 100EH-RE\CUBE to label the LEDs (6 different
stickers, each with two parts)
LED
EtherCAT
Master
EtherCAT
Slave
EtherNet/IP
Powerlink
Open
Modbus/TCP
PROFINET IO
SERCOS III
COM 1 (red/ green) ERR ERR NS BE ERR BF ERR
COM 0 (red/ green) RUN RUN MS BS RUN SF STA
SYS (yellow/green) SYS SYS SYS SYS SYS SYS SYS
RJ45 green LINK L/A IN LINK L/A LINK LINK L/A
Ch0
yellow ACT - ACT - ACT RX/TX -
RJ45 green - L/A OUT LINK L/A LINK LINK L/A
Ch1
yellow - - ACT - ACT RX/TX -
Table 43: LED Labeling depending of the loaded Firmware
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011