cifX Communication Interfaces Real-Time Ethernet - Hilscher

Hardware Installation, Deinstallation and Replacement 142/274
5.12.5 Replacing CIFX 104-RE\F and CIFX 104-RE-R\F
To install the
• CIFX 104-RE\F Communication Interface PC/104(„\F“) and
• CIFX 104-RE-R\F Communication Interface PC/104(„\F“)
handle as follows:
1. Configure starting address, interrupt and data bus width of the CIFX
104-RE\F Communication Interface.
‣ Configure the start address of the CIFX 104-RE\F.
‣ If you are using the interrupt mode, set up a free interrupt on the CIFX
104-RE\F.
For polling operation mode interrupt jumpers are not required.
Note: For the replacement CIFX 104-RE\F you must define a free memory
area of 16 KByte.
For further information on the starting address and or an interrupt (or
polling) refer to section cifX PC/104: Set Starting Address and Interrupt on
page 124.
2. Depending by the target system (motherboard), if so, set at the
replacement CIFX 104-RE\F a Data Bus Width of 8 bit or 16 bit.
By default the jumper is set for a data bus width of 16 Bit (refer to section
Device Drawing CIFX 104-RE\F on page 133 and Device Drawing CIFX
104-RE-R\F on page 134).
3. Take safety precautions.
Lethal Electrical Shock caused by parts with more than 50V!
• Disconnect the power plug of the PC or of the connecting device.
• Make sure, that the power supply is off at the PC or at the connecting
device.
4. Remove the connecting cable to the Master or Slave.
‣ Remove the connecting cable between the CIFX 104-RE\F
Communication Interface to be replaced and the PC card Real-Time
Ethernet Master or Slave.
5. Open cabinet.
‣ Open the cabinet of the PC or of the connecting device.
For more see next page.
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011