cifX Communication Interfaces Real-Time Ethernet - Hilscher

Hardware Installation, Deinstallation and Replacement 127/274
5.11.2 Device Drawing CIFX 104-RE-R
Note:
Device supports
Auto Crossover
Function
Note
With loaded
EtherCAT Master
firmware only RJ-
45 channel 0 can
be used, channel
1 is deactivated.
For Open
Modbus/TCP with
V2.3.4.0 and
higher both
channels can be
used.
Figure 36: Device Drawing CIFX 104-RE-R
The meaning of the LEDs displayed in Figure 36 depends from the loaded
firmware. See chapter LED Descriptions beginning from page 200.
Further refer to Device Connections and Switches page 215:
For the pin assignment of the PCI/104 bus X1/X2 displayed in Figure 36
refer to section Pin Assignment for PC/104 Bus on page 236.
For the SYNC pin assignment of the SYNC Connector displayed in Figure
36 refer to section Pin Assignment SYNC Connector, X51 on page 228.
For further information on the Mini-B USB Connector displayed in Figure
36 refer to section Mini-B USB Connector (5 Pin) on page 221.
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011