cifX Communication Interfaces Real-Time Ethernet - Hilscher

Hardware Installation, Deinstallation and Replacement 72/274
5.4.5 Installing CIFX 50-RE and CIFX 50E-RE
To install the
• CIFX 50-RE Communication Interface PCI and the
• CIFX 50E-RE Communication Interface PCI Express
handle as follows:
1. Fix front plate sticker.
‣ Use the sticker according to the firmware and glue it on the front of the
CIFX 50-RE or CIFX 50E-RE Communication Interface (see section Fix
Front Plate Sticker at CIFX 50-RE and CIFX 50E-RE on page 71).
2. Respectively set Slot Number (Card ID).
‣ For devices with Rotary Switch Slot Number (Card ID) set the Slot
Number (Card ID): (Value 0 or a value from 1 to 9), (see section PCI
and PCI Express: Setting Slot Number (Card ID) on page 67).
Device revisions equipped with a Rotary Switch Slot Number (Card ID)
are listed separately in section Hardware: cifX Communication Interfaces
Real-Time Ethernet in Table 2 on page 17.
3. Take safety precautions.
Lethal Electrical Shock caused by parts with more than 50V!
• Disconnect the power plug of the PC or of the connecting device.
• Make sure, that the power supply is off at the PC or at the connecting
device.
4. Open cabinet.
‣ Open the cabinet of the PC or of the connecting device.
5. Install the CIFX 50-RE Communication Interface PCI.
‣ Plug the CIFX 50-RE into a free PCI slot.
‣ Fix the CIFX 50-RE using the hole intended.
6. Or install CIFX 50E-RE Communication Interface PCI Express.
‣ Plug the CIFX 50E-RE into a free PCI express slot.
‣ Fix the CIFX 50E-RE using the hole intended.
For more see next page.
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011