cifX Communication Interfaces Real-Time Ethernet - Hilscher

Hardware Installation, Deinstallation and Replacement 139/274
After this:
7. Close cabinet.
‣ Close the cabinet of the PC or connecting device.
8. Plug the connecting cable to the Master or Slave.
Important! When using Ethernet TCP/UDP/IP, EtherNet/IP or Modbus
TCP at 10 MBit/s use only switches or 10/100 MBit/s dual-speed hubs and
ensure that the network operates at 100 MBit/s and in full-duplex mode.
For further information refer to section Failure in 10 MBit/s Half Duplex
Mode and Workaround on page 199.
Note: The RJ45 socket is only for use in LAN, not for telecommuni-cation
circuits. For further information refer to section Ethernet Interface on page
219.
‣ Plug the connecting cable from the CIFX 104-RE\F Communication
Interface to the PC card Real-Time Ethernet Master or Slave.
9. Connect the PC or the connecting device to the power supply and
switch it on.
‣ Connect the PC or the connecting device to the power supply.
‣ Switch on the PC or the connecting device.
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011