cifX Communication Interfaces Real-Time Ethernet - Hilscher

Descriptions and Requirements 43/274
3.2.3 Panel Cutout for AIFX Installing
In order to connect the assembly interface AIFX to a cifX Communication
Interface with cable connector Ethernet (labeling „\F“), make sure that the
housing panel of the PC or of the connecting device and the front plate of
the cifX has an appropriate cutout and holes for fastening the AIFX. The
panel cutout must be dimensioned sufficiently large for the interface,
display or control elements placed on the AIFX. Partial standard cutouts
can be used.
cifX
Mini PCI („\F“)
Mini PCI Express („\F“)
PCI 104 („\F“)
PC/104 („\F“)
Panel Cutout
at the housing panel of the PC
on the front plate of the cifX Communication Interface
Table 19: Panel Cutout at the at the housing panel of the PC or on the front plate of the cifX
Communication Interface
cifX AIFX Panel Cutout and Holes
CIFX 90-RE\F
CIFX 90E-RE\F
AIFX-RE Required
Cutout
for two RJ45 Sockets
CIFX 104C-RE\F
CIFX 104C-RE-R\F
CIFX 104-RE\F
CIFX 104-RE-R\F
CIFX 104C-RE\F
CIFX 104C-RE-R\F
CIFX 104-RE\F
CIFX 104-RE-R\F
AIFX-DIAG
Important! The panel cutout layout
must also cover the LEDs COM 0 and
COM1 at the AIFX-RE.
Standard D-Sub-15
cutout
Holes 2, distance between the holes 37,3
mm
Further
Information
Required
Cutout
Standard
cutout
Holes
Further
Information
Table 20: Required Panel Cutout and Holes for AIFX
In the data sheet MOD JACK – MJIM
[2], as well as in section AIFX-RE
Dimensioning on page 215.
for the light channels, the rotary
switches and the Mini B USB plug
-
2, distance between the holes
47,1 mm
in section AIFX-DIAG Dimensioning
on page 217.
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011