cifX Communication Interfaces Real-Time Ethernet - Hilscher

LED Descriptions 212/274
8.11 SERCOS III Master
The subsequent table describes the meaning of the LEDs for the cifX
Communication Interface Real-Time Ethernet Master when the firmware of
the SERCOS III Master protocol is loaded to the device.
LED Color State Meaning
STA
Name in
Duo LED red/green
Blinking CP0: Communication phase 0
the device (green)
drawing:
Flickering Master isn't configured and is in NRT. After a status
COM 0
(green)
change this isn't indicated again
Single Flash CP1: Communication phase 1
(green)
Double Flash CP2: Communication phase 2
(green)
Triple Flash CP3: Communication phase 3
(green)
On CP4: Communication phase 4
(green)
(off)
Off
NRT: Non Real-time Mode
ERR Duo LED red/green
Name in
(red) Blinking Error in the configuration database.
the device
drawing: (red) Flickering Boot-up was stopped due to an error.
COM 1
(red) Single
Channel Init was executed at the Master.
Flickering
(red) Quadruple No Master license present in the device
Flash
(red) Triple Flash DPM Watchdog has expired.
(red) Double Flash Internal Stop of the bus cycle
(red) Single Flash Bus Sync Error Threshold
L/A/RJ45
Ch0 & Ch1
RJ45
Ch0 & Ch1
(off)
Off
No error
LED green
On
Link: A connection to the Ethernet exists
(green)
Flashing Activity: The device sends/receives Ethernet frames
(green)
(off)
Off
The device has no connection to the Ethernet
LED yellow
- - This LED is not used.
Table 61: LEDs SERCOS III Master
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011