BMC Remedy Action Request System 7.6.04: BMC Remedy Mid Tier ...

Table 1-3: AR Server settings
Figure 1-4: Mid Tier Configuration Tool—AR Server Settings page
1 In the Mid Tier Configuration Tool, click AR Server Settings.
To add a new server
2 Click Add Server to open the New Server page.
3 Enter the server name (required).
AR Server settings
Setting Description
Delete/Edit Click in the check box to select a server.
To select all servers in the list, click Select All; to clear all selections in the
list, click Clear All.
Server Name The name of the AR System server that the mid tier is using. The name
must be from a server that AR System recognizes.
The mid tier must be able to resolve this server name to an IP address. The
mid tier must also be able to reach the server through the defined port or
through port 111, if the server is running over the portmapper.
Admin Password The specified password for an AR System account with administrator
privileges.
Set the Mid Tier Administration Password under the Connection Settings
tab in the AR System Administration: Server Information form. (If a
password has been entered for a server, asterisks appear in this column
instead of the actual password characters.) Version 7.0 and later
AR System servers require a password.
Port The port number you previously configured to access the AR System
server. If you have not configured a port number, this field is blank.
RPC The Remote Procedure Call (RPC) protocol number that the server will
use. This number can be used for connecting to a private server. If you
have not configured an RPC number, this field is blank.
Pre-Load Specifies whether preloading of forms to the system’s memory is enabled
for the server.
Chapter 1 Configuring the mid tier 27