C55/C55i AT COMMAND SET Description Preliminary - Falcom

C55/C55I AT COMMAND SET VERSION 1.00
6.6 ATD> Originate call to phone number in memory with
corresponding field
Syntax
Exec Command
ATDxstr>[];
Reference(s) PIN ASC0
V.25ter ● ●
Response(s)
ERROR
+CME ERROR:
If no dialtone (parameter ATX2 or ATX4):
NO DIALTONE
If busy (parameter setting ATX3 or ATX4):
BUSY
If connection cannot be set up:
NO CARRIER
When TA returns to command mode after call
release:
OK
If successfully connected:
OK
Command Description
This command searches the active phone book for a given string
and dials the assigned phone number. The termination character ";" is
mandatory since dialing from a phone book is only supported for
voice calls and for sending *# codes of Supplementary Services or
other functions.
Parameter Description
(str)(+CSCS)
String type value ("x"), which should equal an alphanumeric field in at
least one phone book entry in the searched memories; used character
set should be the one selected with AT+CSCS. can contain escape
sequences as described in chapter 0.5 "Supported character sets".
must be wrapped in quotation marks (" "), if escape sequences or
parameter are used or if the alphanumeric strings contains a
blank. If not, quotation marks are optional.
If AT+CSCS is set to "UCS2", with respect to the coding of UCS2characters
only phone book entries that contain an alphanumeric string
with assize less than the half of the paramter from AT+CPBW
can be dialed.
(str)
String of GSM modifiers:
I Activates CLIR (disables presentation of own phone
number to called party)
i Deactivates CLIR (enables presentation of own
phone number to called party)
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 106