C55/C55i AT COMMAND SET Description Preliminary - Falcom

C55/C55I AT COMMAND SET VERSION 1.00
^ SCFG:"URC/Datamode/Ringline","on" URCs while TA-TE link is
reserved will be indicated by an
activated "local" RING line.
OK
AT ^ SCFG="URC/Ringline","asc0"
^ SCFG:"URC/Ringline","asc0" URCs on this (!) interface will be
indicated by an activated RING0
regardless whether or not the TA-
TE link is reserved.
OK
AT ^ SCFG="URC/Datamode/Ringline","off"
^ SCFG:"URC/Datamode/Ringline","off" URCs on this (!) interface
will be indicated by an activated
RING0 if TA-TE link is not (!)
reserved and by BREAK if TA-TE
link is reserved.
OK
AT ^ SCFG="URC/Ringline" Disable any RING line indication
for URCs on this interface.
^ SCFG:"URC/Ringline","off"
OK
1.14 AT ^ SM20 Set M20 compatibility mode
Syntax
Test Command
AT^SM20=?
Read Command
AT^SM20?
Write Command
AT^SM20 = [, ]
Reference(s) PIN ASC0
SIEMENS ○ ●
Response(s)
OK
Response(s)
^SM20: :,
OK
Response(s)
OK
Command Description
The AT^SM20 command selects different modes of responses returned
upon execution of the commands ATD and SMS commands like e.g.
AT+CMGW.
Parameter Description
(num)
Call setup response mode
Applies only to voice calls.
0 Set compatibility to Siemens mobile phones.
ME will return "OK" immediately after attempting a
call with the ATD command. In case of failure,
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 43