C55/C55i AT COMMAND SET Description Preliminary - Falcom

More documents

Recommendations

Info

C55/C55I AT COMMAND SET VERSION 1.00 2.4.11 SIEMENS release cause for Session Management (SM) Number Description 3 The MS has not got any answer to the ACTIVATE PDP CONTEXT request message sent five times to the network 4 A MT PDP context which is active or in the activation process is deactivated because another MT PDP context with the same TI is requested by the network to be activated 5 A MT PDP context which is active or in the activation process is deactivated because another MT PDP context with the same TI is requested by the network to be activated. The activation request is rejected by the SM sending the cause 'insufficient resources' to the network because the SM was not able to perform the necessary comparisons for a static PDP address collision detection. 6 A MT PDP context which is active or in the activation process is deactivated because another MT PDP context with the same TI is requested by the network to be activated. As a static PDP address collision with an MO activating PDP context has been detected by the SM the SM discards the activation request 7 A MT PDP context request has been indicated but could not be processed in time. The activation request is rejected by the SM sending the cause 'insufficient resources' to the network. 2.4.12 GSM cause for L3 Protocol module or other local cause Number Description 2 No detailed cause 2.4.13 SIEMENS release cause for GPRS API Number Description 0 Regular deactivation of the call 1 Action temporarily not allowed 2 Wrong connection type 3 Specified data service profile invalid 4 PDP type or address is unknown 255 Undefined 2.4.14 SIEMENS release cause for Embedded Netcore Number Description 0 Regular call deactivation 1 LCP stopped 255 Undefined This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission. Page 62
C55/C55I AT COMMAND SET VERSION 1.00 2.5 ATS18 Extended call release report Syntax Read Command ATS18? Write Command ATS18= Response(s) OK Response(s) OK Reference(s) PIN ASC0 V.25ter ○ ● Command Description This command enables or disables the presentation of extended call release reports for fax and data calls. The call release report is presented in numeric format and includes the following parameters: +CAUSE: , If enabled the message will be reported every time a fax or data call is released or fails to be established. Parameter Description (num)(&W)(&V) An odd number enables the presentation of the extended call release report. An even number disables this feature. 0 (&F) ...255 (num) Location ID as number code (see also of AT+CEER). Location IDs are listed in section 2.4.1. Each ID is related to another table that contains a list of s. (num) Reason for last call release as number code (see also of AT+CEER). numbers and the associated descriptions are listed in several tables, sorted by different categories in chapter AT+CEER. The tables can be found proceeding from the Location IDs listed in 2.4.1. Note • The command applies only to circuit switched data and fax calls. For voice calls extended call release reports can be retrieved using the command AT+CEER. Examples EXAMPLE 1 ATS18=1 Enables the presentation of extended call release reports. OK ATD03012345678 Now, a mobile originated data call fails. +CAUSE: 8:17 An extended error report is output, followed by the result code BUSY. BUSY The Location ID 8 stated in section 2.4.1 points to section 2.4.6, where 17 = "User busy". This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission. Page 63
Page 1 and 2:
This document is available at HTTP:
Page 3 and 4:
C55/C55I AT COMMAND SET VERSION 1.0
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12: C55/C55I AT COMMAND SET VERSION 1.0
Page 61: C55/C55I AT COMMAND SET VERSION 1.0
Page 89 and 90: XF55 AT COMMAND SET VERSION 1.00 4.
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
Page 267 and 268:
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
Page 301 and 302:
show all

C55/C55i AT COMMAND SET Description Preliminary - Falcom

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?