C55/C55i AT COMMAND SET Description Preliminary - Falcom
C55/C55i AT COMMAND SET Description Preliminary - Falcom
C55/C55i AT COMMAND SET Description Preliminary - Falcom
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>C55</strong>/<strong>C55</strong>I <strong>AT</strong> <strong>COMMAND</strong> <strong>SET</strong> VERSION 1.00<br />
assign a different setting to a specific class. For<br />
example, you can activate Call Forwarding for all<br />
data classes, but deactivate it for data class 64,<br />
"dedicated packet access".<br />
4 fax<br />
8 SMS<br />
16 data circuit sync<br />
32 data circuit async<br />
64 dedicated packet access<br />
128 dedicated PAD access<br />
1...[7]...255 combination of some of the above classes.<br />
For example, the default setting 7 represents the<br />
sum of the integers 1, 2 and 4 (voice, data and fax).<br />
The value 255 covers all classes.<br />
If parameter "class" is omitted, the default value 7<br />
is used.<br />
Notes<br />
• The <strong>AT</strong>+CLCK command offers the full range of <br />
parameters according to the GSM specifications. However, when<br />
you attempt to use a service option which is not provisioned or not<br />
yet subscribed to, the setting will not take effect regardless of the<br />
response returned.<br />
The responses in these cases vary with the network (for example<br />
"OK", "Operation not allowed", "Operation not supported" etc.). To<br />
make sure check the extended error response with <strong>AT</strong>+CEER and the<br />
lock status with =2.<br />
• The command has been implemented with the full set of <br />
parameters according to GSM 07.07. For actual applicability of a<br />
desired Call barring service to a specific service or service group (a<br />
specific value) please consumable A.1 of GSM 02.04.<br />
• If an outgoing Fax or Data Call is rejected due to an active "call<br />
barring" supplementary service, the call will be terminated with<br />
result code NO CARRIER.<br />
Under the same conditions, an outgoing Voice call will be<br />
terminated with result code NO DIALTONE.<br />
Examples<br />
EXAMPLE 1<br />
Lock SIM card (= "SC")<br />
<strong>AT</strong>+CLCK="SC", 1, "9999" The"SC" parameter enables or disables<br />
the SIM PIN authentication (PIN 1)<br />
when you power up the GSM engine<br />
SIM card locked. As a result, SIM PIN<br />
1 must be entered to enable ME to<br />
register to the GSM network.<br />
OK<br />
<strong>AT</strong>+CLCK="SC",0, "9999" Unlocks SIM card.<br />
When powered up, ME registers to the<br />
GSM network without requesting SIM<br />
PIN1. Note: Depending on the services<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 86