C55/C55i AT COMMAND SET Description Preliminary - Falcom

More documents

Recommendations

Info

C55/C55I AT COMMAND SET VERSION 1.00 Received signal level of the BCCH carrier (0..63). The indicated value is composed of the measured value in dBm plus an offset. This is in accordance with a formula specified in 3GPP TS 05.08 (num) Coefficient for base station reselection, e.g. 30. In dedicated mode, under certain conditions the parameter cannot be updated. In such cases a '-' is presented. Coefficient for base station reselection, e.g. 30. In dedicated mode, under certain conditions the parameter cannot be updated. In such cases a '-' is presented. Note • To some extent, the cell monitoring commands AT^MONI, AT^MONP and AT^SMONC cover the same parameters. The receiving level, for example, can be queried with all three commands. Yet the resulting values may be slightly different, even though obtained over a time period of a few seconds. This is quite normal and nothing to worry about, as the cell information is permanently updated. ^ 7.6 AT MONI Monitor idle mode and dedicated mode Syntax (num) Test Command AT^MONI=? Exec Command AT^MONI Response(s) ^MONI : (list of supported s) OK Response(s) See: 7.6.1 OK Write Command Response(s) See: 7.6.1 AT^MONI= OK Reference(s) PIN ASC0 SIEMENS ○ ● Command Description The execute command can be used to retrieve the cell parameters of the serving/dedicated cell on request. The write command can be used to retrieve information of the serving/dedicated cell automatically every seconds. To stop the presentation type "AT" or "at". Parameter Description (num) Display period in seconds 1...254 Notes • The two header lines (see 7.6.1) are output after every ten data lines. • The length of following output lines exceeds 80 characters. Therefore a terminal program may draw a carriage return on a screen. However, this is not part of the response. This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission. Page 136
C55/C55I AT COMMAND SET VERSION 1.00 7.6.1 AT ^ MONI responses ME is not connected: a) ME is camping on a cell and registered to the network: Serving Cell I Dedicated channel chann rs dBm PLMN LAC cell NCC BCC PWR RXLev C1 I chann TS timAdv PWR dBm Q ChMod 1013 21 -71 00101 1001 0103 7 7 33 -105 33 I No connection b) ME is camping on a cell but not registered to the network (only emergency call allowed): Serving Cell I Dedicated channel chann rs dBm PLMN LAC cell NCC BCC PWR RXLev C1 I chann TS timAdv PWR dBm Q ChMod 1013 21 -71 00101 1001 0103 7 7 33 -105 33 I Limited Service c) ME camping on a cell, but searching for a better cell (cell reselection): Serving Cell I Dedicated channel chann rs dBm PLMN LAC cell NCC BCC PWR RXLev C1 I chann TS timAdv PWR dBm Q ChMod 1013 21 -71 00101 1001 0103 7 7 33 -105 33 I Cell Reselection d) ME is searching and could not (yet) find a suitable cell: Serving Cell I Dedicated channel chann rs dBm PLMN LAC cell NCC BCC PWR RXLev C1 I chann TS timAdv PWR dBm Q ChMod Searching e) ME is connected (Call in progress): Serving Cell I Dedicated channel chann rs dBm PLMN LAC cell NCC BCC PWR RXLev C1 I chann TS timAdv PWR dBm Q ChMod 1013 19 -76 00101 1001 0103 7 7 33 -105 33 I 1015 1 0 5 -76 0 S_HR Columns for Serving Cell: Column Description chann ARFCN (Absolute Frequency Channel Number) of the BCCH carrier rs RSSI value 0 - 63 (RSSI = Received signal strength indication) dBm receiving level of the BCCH carrier in dBm PLMN PLMN ID code LAC location area code, see note below cell cell ID, see note below NCC PLMN colour code BCC base station colour code PWR maximal power level used on RACH channel in dBm RXLev minimal receiving level (in dBm) to allow registration C1 coefficient for base station selection This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission. Page 137
Page 1 and 2:
This document is available at HTTP:
Page 3 and 4:
C55/C55I AT COMMAND SET VERSION 1.0
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86: C55/C55I AT COMMAND SET VERSION 1.0
Page 89 and 90: XF55 AT COMMAND SET VERSION 1.00 4.
Page 135: C55/C55I AT COMMAND SET VERSION 1.0
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
Page 267 and 268:
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
Page 301 and 302:
show all

C55/C55i AT COMMAND SET Description Preliminary - Falcom

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?