C55/C55i AT COMMAND SET Description Preliminary - Falcom

C55/C55I AT COMMAND SET VERSION 1.00
16 Miscellaneous Commands
The AT commands described in this chapter are related to various areas.
16.1 A/Repeat previous command line
Syntax
Exec Command Response(s)
A/
Reference(s) PIN ASC0
V.25ter ○ ●
Command Description
Repeat previous command line.
Notes
• Line does not need to end with terminating character.
• After beginning with the character "a" or "A" a second character
"t", "T" or "/" has to follow. In case of using a
•
wrong second character, it is necessary to start again with character
"a" or "A".
If autobauding is active, the command A/ cannot be used (see
AT+IPR).
16.2 ATS3 Write command line termination character
Syntax
Read Command
ATS3?
Write Command
ATS3=
Response(s)
OK
Response(s)
OK
Reference(s) PIN ASC0
V.25ter ○ ●
Command Description
This parameter setting determines the character recognized by TA to
terminate an incoming command line.
Parameter Description
(num)(&W)(&V)
command line termination character
000...13
(&F) ...127
Note
• Using other value than 13 may cause problems when entering
commands.
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 280