C55/C55i AT COMMAND SET Description Preliminary - Falcom

C55/C55I AT COMMAND SET VERSION 1.00
Broadcast Type Messages:
0 Type not supported
1 Type supported
Notes
• If CSMS mode is switched from Phase 2+ to Phase 2 and one or
more AT+CNMI parameter are Phase 2+ specific a '+CMS ERROR:
unknown error' will appear. It is recommended to switch the
AT+CNMI parameters to Phase 2 specific values before entering
Phase 2.
• Phase 2+ (=1) must be set before the following features
can be used:
- Configuring procedures for indicating received short messages
with the AT+CNMI parameters =2 or =3 and =1.
- Acknowledging incoming short messages with AT+CNMA.
- Receiving Status Reports and acknowledging them with
AT+CNMA.
^
11.18 AT SLMS List SMS Memory Storage
Syntax
Test Command
AT^CLMS=?
Exec Command
AT^SLMS
Response(s)
OK
Reference(s) PIN ASC0
SIEMENS ● ●
Response(s)
^SLMS: "MT",
^SLMS: "SM",,
^SLMS: "ME",,
OK
ERROR
+CMS ERROR
Command Description
The execute command indicates the maximum capacity of each SMS
storage type and the number of locations currently used.
Parameter Description
(num)
Maximum number of messages storable in the SMS memory of the
SIM (physical storage "SM")
(num)
Maximum number of messages storable in the SMS memory of the
Mobile Equipment (physical storage "ME")
(num)
Sum of "SM" and "ME", indicated as "MT". Maximum number of
all messages storable in the SIM memory and the Mobile Equipment
memory.
(num)
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 233