C55/C55i AT COMMAND SET Description Preliminary - Falcom

C55/C55I AT COMMAND SET VERSION 1.00
Command Description
This command defines the "Copy-Quality-OK" multiplier. The
number of lines received with a bad pixel count is multiplied by this
number. If the result exceeds the total number of lines on the page
the error rate is considered too high. A threshold multiplier value of
20 corresponds to a 5 per cent error rate. A value of 0 implies that
error checking is not present or disabled.
Parameter Description
(num)
0...20 (P) ...255
Note
• Used for Fax Class 2 only
10.4 AT+FBOR Query data bit order
Syntax
Test Command
AT+FBOR=?
Read Command
AT+FBOR?
Write Command
AT+FBOR=
Response(s)
(list of supported s)
OK
Response(s)
OK
Response(s)
OK
Reference(s) PIN ASC0
EIA PN-2388 ○ ●
Command Description
Query the bit order for receive-mode. The mode is set by the ME
depending on the selected Service Class, see "AT+FCLASS Fax:
Select, read or test service class".
Parameter Description
(num)
bit order modes
0 Direct bit order for both Phase C and for Phase B/D data.
[1] Reversed bit order for Phase C data, direct Bit Order for
Phase B/D data.
Note
• Used for Fax Class 2 only
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 198