C55/C55i AT COMMAND SET Description Preliminary - Falcom

C55/C55I AT COMMAND SET VERSION 1.00
• To access an entry found with at^spbs for editing or dialing,
enter at^spbs with the parameter =1. Then
extract the "real" location number of the entry from response
parameter and use this "real" location number
with ATD> or at+cpbw.
See examples below.
Parameter Description
(num)
1 To make a step forward in the alphabetically sorted phone
book.
2 To make a step backward in the alphabetically sorted phone
book.
(num)
1….maxindex The index in the sorted list of phone book entries
that identifies the first entry displayed.
The value of is determined by the value
of the and by parameter
.
After a write command has terminated successfully
with "OK", the value from parameter is
saved and retained as the new
value.
(num)
1...maxindex The index in the sorted list of phone book entries
that identifies the third entry displayed.
= (+1).
Mind after the last record of phone book, the first
entry follows.
(num)
1...maxindex The index in the sorted list of phone book entries
that identifies the third entry displayed.
= (+1).
Mind after the last record of phone book, the first
entry follows.
(num)
Mind after the last record of phone book, the first entry follows.
(str) string type phone number in format specified by
. The number parameter may be an empty string.
(num)
type of address octet
145 dialling string includes international access
code character'+'
209 dialling string contains printable nonalphabetic
non-digit characters saved with the number
string.
For phone book entries with this , dialling from
phone book with ATD> is not possible. For
further detail, check the parameter descriptions for at
command at+cpbw.
129 otherwise
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 258