C55/C55i AT COMMAND SET Description Preliminary - Falcom
C55/C55i AT COMMAND SET Description Preliminary - Falcom
C55/C55i AT COMMAND SET Description Preliminary - Falcom
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>C55</strong>/<strong>C55</strong>I <strong>AT</strong> <strong>COMMAND</strong> <strong>SET</strong> VERSION 1.00<br />
information is received from the new base station, the default values<br />
will be shown instead: cell="0000", NCC="-", BCC="-".<br />
If the BS supports frequency hopping during a connection, the<br />
dedicated channel (parameter chann) is not stable. This mode is<br />
indicated by chann = 'h'.<br />
• To some extent, the cell monitoring command <strong>AT</strong>^SMONC covers the<br />
same parameters. The receiving level, for example, can be queried with<br />
both commands. Yet the resulting values may be slightly different, even<br />
though obtained over a time period of a few seconds. This is quite<br />
normal and nothing to worry about, as the cell information is<br />
permanently updated.<br />
• For compatibility with earlier products and to support legacy<br />
applications, any input character may be used to stop the output in<br />
certain cases (depending on the settings of 3.7 and 0.1).<br />
^<br />
7.7 <strong>AT</strong> MONP Monitor neighbour cells<br />
Syntax<br />
Test Command<br />
<strong>AT</strong>^MONP=?<br />
Exec Command<br />
<strong>AT</strong>^MONP<br />
Write Command<br />
<strong>AT</strong>^MONP=<br />
Response(s)<br />
^MONP: (list of supported s)<br />
OK<br />
Response(s) See: 7.7.1<br />
OK<br />
Response(s) See: 7.7.1<br />
OK<br />
Reference(s) PIN ASC0<br />
SIEMENS ○ ●<br />
Command <strong>Description</strong><br />
This command can be used to obtain information of up to six<br />
neighbour cells on request.<br />
This command can be used to retrieve information of up to six<br />
neighbour cells automatically every n seconds. To stop the<br />
presentation type "at" or "<strong>AT</strong>".<br />
Parameter <strong>Description</strong><br />
(num)<br />
<br />
Display period in seconds<br />
1...254<br />
Note<br />
• Due to the fact that not all necessary information of the neighbour<br />
cells can be decoded during a connection, there are several<br />
constraints to be considered:<br />
- Only neighbour cells that have already been visible in IDLE<br />
mode will be further updated, as long as they are still included in<br />
the list.<br />
- Though new neighbour cells can be added to the list (e.g. due to<br />
handover), their C1 and C2 parameters cannot be displayed until<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 139