C55/C55i AT COMMAND SET Description Preliminary - Falcom

C55/C55I AT COMMAND SET VERSION 1.00
7.8 AT ^ SMONG GPRS Monitor
Syntax
Test Command
AT^SMONG=?
Exec Command
AT^SMONG
Write Command
AT^SMONG=[, ]
Reference(s) PIN ASC0
SIEMENS ● ●
Response(s)
^SMONG: (list of supported s), (list of
supported s)
OK
Response(s)
GPRS Monitor
Cell Info Table (see: 7.7.1)
OK
Response(s)
^SMONG: GPRS Monitor Cell Info Table (see:
7.7.1)
OK
ERROR
+CME ERROR
Command Description
The execute command can be used to retrieve GPRS specific cell
information directly on request. The cell data will be output only once
on a single line.
The write command can be used to retrieve GPRS specific cell
information directly on request or automatically every n seconds. To
stop the presentation type "at" or "AT".
Parameter Description
(num)
1 Cell Info Table
(num)
Display period in seconds
If is omitted the cell data will be presented only once on a
single line (as if Execute command was issued).
If is given, the cell data will be listed repeatedly on 10 data
lines. Every 10 th data line is followed by the header, simply to repeat
the column titles.
1...100
Note
•
For compatibility with earlier products and to support legacy
applications, often any input character will stop the periodic output
of the write command. But since this applies only in certain cases
(depending on the settings of chapter 3.7 and 0.1), it is
recommended to always use "at" or "AT".
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 141