C55/C55i AT COMMAND SET Description Preliminary - Falcom

More documents

Recommendations

Info

C55/C55I AT COMMAND SET VERSION 1.00 • The , and parameter will be stored in non-volatile memory. • The user should be aware that the setting "MT" involves "ME" and "SM", with "ME" being filled up first. If the "ME" storage is full, C55 will proceed with the "SM" storage. Incoming Class 1 short messages (ME specific) will be preferably stored to "ME" and may be transferred to the "SM" storage if "ME" is used up. Incoming Class 2 messages (SIM specific) will be stored to the SIM card only, no matter whether or not there is free "ME" space. As a result, the ^ SMGO: 2 indication (see AT^SMGO) may be presented without prior indication of A SMGO: 1. For more information regarding SIM and ME specific message classes refer to and the following specifications: GSM 03.38 and 3GPP TS23038. • When is switched over from "MT" to "SM" all free "ME" locations will be filled with dummy short messages. This procedure can take up to 35 seconds, until all the 25 records are written. If switching from "MT" to "SM" was not finished due to error or user break, the value of remains "MT", but some of the dummy records remain in the "ME" storage. These records have to be deleted manually. When equals "SM", do not delete the dummy messages in the "ME", storage. They will be automatically deleted when you switch back from "SM" to "MT". Again, this may take up to 35 seconds. If switching from "SM" to "MT" was not finished due to an error or user break, the value of remains "SM", but the "ME" storage will no longer be filled with dummy records. New incoming short messages may now be written to the "ME" storage, if "SM" is already full. To avoid this, repeat the AT+CPMS command as soon as possible to switch back to "MT". As an alternative, you can manually delete the dummy records and issue AT+CPMS=MT,MT,MT. • While equals "SM" and equals "ME" it is possible that, after deleting short messages from "ME", the freed space on "ME" is reclaimed for new incoming short messages, when there is no space left on the "SM" storage. As it is often the clients concern to have received short messages stored only to the SIM card, inconsistent settings should be generally avoided. This can be achieved simply by using the same parameter for all memory indices. • The indices of the storage are dependent on the order selected with AT^SSMSS. This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission. Page 228
C55/C55I AT COMMAND SET VERSION 1.00 11.13 AT+CSCA SMS service centre address Syntax Test Command AT+CSCA=? Read Command AT+CSCA? Write Command AT+CSCA=[, ] Response(s) OK Response(s) +CSCA: , OK Response(s) OK Reference(s) PIN ASC0 GSM 07.05 ● ● Command Description Write command updates the SMSC address, through which mobile originated SMS are transmitted. In text mode, setting is used by send and write commands. In PDU mode, setting is used by the same commands, but only when the length of the SMSC address coded into parameter equals zero. Notes • In case of using no parameter after AT+CSCA= the content of will be deleted. • This command writes the service centre address to non-volatile memo. • The SMS service centre address should be entered as specified by the service provider. 11.14 AT+CSCB Select Cell Broadcast Message Indication Syntax Test Command AT+CSCB=? Read Command AT+CSCB? Write Command AT+CSCB=[[, [, ]]] Response(s) +CSCB: (list of supported s) OK Response(s) + CSCB: , , OK Response(s) OK Reference(s) PIN ASC0 GSM 07.05 ● ● Command Description Test command returns supported modes as a compound value. Write command selects which types of CBMs are to be received by the ME. This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission. Page 229
Page 1 and 2:
This document is available at HTTP:
Page 3 and 4:
C55/C55I AT COMMAND SET VERSION 1.0
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
XF55 AT COMMAND SET VERSION 1.00 4.
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178: C55/C55I AT COMMAND SET VERSION 1.0
Page 227: C55/C55I AT COMMAND SET VERSION 1.0
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
Page 301 and 302:
show all

C55/C55i AT COMMAND SET Description Preliminary - Falcom

Create successful ePaper yourself

Delete template?

Save as template?