C55/C55i AT COMMAND SET Description Preliminary - Falcom

C55/C55I AT COMMAND SET VERSION 1.00
The logical name that is used to select the GGSN or the external
packet data network. If the value is null or omitted, then the
subscription value will be requested.
(str)
Packet Data Protocol address
Identifies the MT in the address space applicable to PDP (e.g. IP V4
address for PDP type IP). If the value is null or omitted, then a value
may be provided by the TE during the PDP startup procedure or,
failing that, a dynamic address will be requested. The read command
will continue to return the null string even if an address has been
allocated during the PDP startup procedure. The allocated address
may be read using AT+CGPADDR.
(num) Data Compression
Controls the PDP data compression (applicable for Subnetwork
Dependent Convergence Protocol (SNDCP) only) 3GPP TS 44.065
[0] off
(num)
Header Compression
Controls the PDP header compression 3GPP TS 44.065, 3GPP TS
25.323
[0] off
Notes
• The MT supports PDP type IP only.
• AT&F and ATZ will undefine every context which is not active or
not online.
9.7 AT+CGPADDR Show PDP address
Syntax
Test Command
AT+CGPADDR=?
Write Command
AT+CGPADDR=[[[...]]]
Reference(s) PIN
GSM 07.07 ● ●
Response(s)
+CGPADDR: (list of supported s)
OK
Response(s)
+ CGPADDR: ,
+ CGPADDR: ...
OK
ERROR
+CME ERROR
ASC0
Command Description
The test command returns a list of defined s.
The write command returns a list of PDP addresses for the specified
context identifiers.
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 176