C55/C55i AT COMMAND SET Description Preliminary - Falcom
C55/C55i AT COMMAND SET Description Preliminary - Falcom
C55/C55i AT COMMAND SET Description Preliminary - Falcom
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>C55</strong>/<strong>C55</strong>I <strong>AT</strong> <strong>COMMAND</strong> <strong>SET</strong> VERSION 1.00<br />
10 FAX Commands<br />
The following commands can be used for FAX transmission. If the ME is<br />
acting as a Fax-Modem to a PC-based application (e.g. "WinFax") it is<br />
necessary to select the proper Service Class (Fax Class) provided by the<br />
ME. The ME reports its Service Class capabilities, both the current setting<br />
and the range of services avaible. This is provided by the <strong>AT</strong>+FCLASS<br />
command. Service Classes supported by ME:<br />
<strong>AT</strong>+FCLASS Parameter Service class Reference, Standard<br />
0 data modem e.g. TIA/EIA-602 or ITU V.25ter<br />
1 Service Class 1 EIA/TIA-578-A<br />
2 manufacture specific this document and EIA PN-2388<br />
(draft)<br />
The following <strong>AT</strong> commands are dummy commands:<br />
<strong>AT</strong>+FAA Auto Answer mode<br />
<strong>AT</strong>+FECM Error Correction Mode control<br />
<strong>AT</strong>+FLNFC Page Length format conversion<br />
<strong>AT</strong>+FLPL Indicate document available for polling<br />
<strong>AT</strong>+FMINSP Minimum Phase C speed<br />
<strong>AT</strong>+FRBC Phase C data receive byte count<br />
<strong>AT</strong>+FREL Phase C received EOL alignment<br />
<strong>AT</strong>+FSPL Enable polling<br />
<strong>AT</strong>+FTBC Phase C data transmit byte count<br />
<strong>AT</strong>+FWDFC Page width format conversion<br />
Invoking these commands will not cause ERROR result codes, but these<br />
commands have no functionality.<br />
10.1 FAX parameters<br />
Parameter <strong>Description</strong><br />
(num) <br />
Binary File Transfer Mode<br />
Note: Only the default value needs to be implemented. Use test<br />
command to check which parameter values are really possible!<br />
[0] disable BFT<br />
1 enable BFT<br />
(num) <br />
Bit Rate<br />
0 2400 bit/s, V.27ter<br />
1 4800 bit/s, V.27ter<br />
2 7200 bit/s, V.29<br />
[3] 9600 bit/s, V.29<br />
(num) <br />
Data Compression Format<br />
Note: Only the default value needs to be implemented. Use test<br />
command to check which parameter values are really possible!<br />
[0] 1-D modified Huffman<br />
1 2-D modified read<br />
2 2-D uncompressed mode<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 195
Change language