C55/C55i AT COMMAND SET Description Preliminary - Falcom

C55/C55I AT COMMAND SET VERSION 1.00
1 Configuration Commands
The AT commands described in this chapter allow the application to
determine the C55's behaviour under various conditions.
1.1 AT&F Set all current parameters to manufacturer defaults
Syntax
Exec Command
AT&F[]
Response(s)
OK
Reference(s) PIN ASC0
V.25ter ○ ●
Command Description
TA sets all current parameters to the manufacturer defined profile.
Parameter Description
(num)
[0] set all TA parameters to manufacturer defaults
Notes
• List of parameters reset to manufacturer default can be found in
chapter 0.
• In addition to the default profile, you can store an individual one
with AT&W. To alternate between the two profiles enter either ATZ
(loads user profile) or AT&F (restores factory profile).
• Every ongoing or incoming call will be terminated.
1.2 AT&V Display current configuration
Syntax
Exec Command
AT&V[]
Response(s)
ACTIVE PROFILE:
... (see section 1.2.1)
OK
Reference(s) PIN ASC0
V.25ter ○ ●
Command Description
TA returns the current parameter setting. The configuration varies
depending on whether or not PIN authentication has been done. .
Parameter Description
(num)
[0] Profile number
Notes
• The parameters of AT^SMGO can only be displayed after the SMS
data from the SIM have been read success fully for the first time.
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 21