C55/C55i AT COMMAND SET Description Preliminary - Falcom

More documents

Recommendations

Info

C55/C55I AT COMMAND SET VERSION 1.00 book's data has been read from the SIM successfully. Reading starts after successful SIM authentication has been performed and may take up to 30 seconds depending on the SIM used. While this read process is in progress, an attempt to use any of the phone book commands will result in "+CME Error: SIM busy". Syntax Test Command AT+CPBR=? Write Command AT+CPBR=[, ] Response(s) + CPBR: (1-), , OK +CME ERROR Reference(s) PIN ASC0 GSM 07.05, GSM 11.11 ● ● Response(s) [+CPBR: , , , ] [+CPBR: , , , ] OK +CME ERROR Command Description The test command returns the location range supported by the current phone book storage, the maximum length of field and the maximum length of field. Note: Length information may not be available while SIM storage is selected. If storage does not offer format information, the format list contains empty parenthesizes. The write command determines the phone book entry to be displayed with or a location range from to . Hence, if no is given only the entry at will be displayed. If no entries are found at the selected location "OK" will be returned. Parameter Description (num) The first (lowest) location number within phone book memory for which the corresponding entry is to be displayed. The supported range is given in the test command response. If exceeds the upper bound (as indicated by the test command), command will respond with "+CME ERROR: INVALID INDEX". (num) The last (highest) location number within phone book memory for which the corresponding entry is to be displayed. The supported range is given in the test command response. If both and are in the range indicated by the test command with parameter , the list of entries will be output and terminated with "OK". This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission. Page 244
C55/C55I AT COMMAND SET VERSION 1.00 If exceeds the range indicated by the test command with parameter , the list of entries will be output but terminated with "+CME ERROR: INVALID INDEX". (str) Phone number in format specified by , it may be an empty string. (num) Address type 145 dialling string includes international access code character'+' 209 dialling string contains printable nonalphabetic non-digit characters saved with the number string. For phone book entries with this , dialling from phone book with ATD> is not possible. For further detail, check the parameter descriptions for at command AT+CPBW. 129 otherwise (str)(+cscs) Text assigned to a phone number. The maximum length for this parameter is given with test command response parameter . If using an ASCII terminal characters which are coded differently in ASCII and GSM have to be entered via escape sequences as described in chapter Supported character sets. (num) Maximum location number for the currently selected storage. For phone books located on the SIM this value depends on the SIM card type. (num) Maximum length of phone number for "normal" locations. Depending on the storage a limited number of locations with extended memory is available per phone book. These locations allow storing numbers with twice the standard length, which is 2* digits for normal numbers, but only digits for numbers saved with =209. (num) Maximum length of assigned to the telephone number. The value indicated by the test command is given in octets. If is given as GSM characters each character corresponds to one octet. If the string is given in UCS2, the maximum number of characters depends on the coding scheme used for the alpha field of the SIM according to GSM 11.11, Annex B [7]. As a worst case the number of UCS2 characters is less than half the number of GSM characters. For a detailed description please refer to GSM 11.11, Annex B [7]. Examples: EXAMPLE 1 First run the test command to find out the maximum range of entries stored in the active phone book AT+CPBR=? + CPBR: (1-100) ,20,17 This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission. Page 245
Page 1 and 2:
This document is available at HTTP:
Page 3 and 4:
C55/C55I AT COMMAND SET VERSION 1.0
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
XF55 AT COMMAND SET VERSION 1.00 4.
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194: C55/C55I AT COMMAND SET VERSION 1.0
Page 243: C55/C55I AT COMMAND SET VERSION 1.0
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
Page 301 and 302:
show all

C55/C55i AT COMMAND SET Description Preliminary - Falcom

Create successful ePaper yourself

Delete template?

Save as template?