C55/C55i AT COMMAND SET Description Preliminary - Falcom

C55/C55I AT COMMAND SET VERSION 1.00
2.5 ATS18 Extended call release report
Syntax
Read Command
ATS18?
Write Command
ATS18=
Response(s)
OK
Response(s)
OK
Reference(s) PIN ASC0
V.25ter ○ ●
Command Description
This command enables or disables the presentation of extended call
release reports for fax and data calls. The call release report is
presented in numeric format and includes the following parameters:
+CAUSE: ,
If enabled the message will be reported every time a fax or data call is
released or fails to be established.
Parameter Description
(num)(&W)(&V)
An odd number enables the presentation of the extended call release
report. An even number disables this feature.
0 (&F) ...255
(num)
Location ID as number code (see also of AT+CEER).
Location IDs are listed in section 2.4.1. Each ID is related to another
table that contains a list of s.
(num)
Reason for last call release as number code (see also of
AT+CEER). numbers and the associated descriptions are
listed in several tables, sorted by different categories in chapter
AT+CEER. The tables can be found proceeding from the Location IDs
listed in 2.4.1.
Note
• The command applies only to circuit switched data and fax calls. For
voice calls extended call release reports can be retrieved using the
command AT+CEER.
Examples
EXAMPLE 1
ATS18=1 Enables the presentation of extended call release
reports.
OK
ATD03012345678 Now, a mobile originated data call fails.
+CAUSE: 8:17 An extended error report is output, followed by the
result code BUSY.
BUSY The Location ID 8 stated in section 2.4.1 points to
section 2.4.6, where 17 = "User busy".
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 63