C55/C55i AT COMMAND SET Description Preliminary - Falcom

C55/C55I AT COMMAND SET VERSION 1.00
15 Hardware related Commands
The AT commands described in this chapter are related to the C55's
hardware interface. More information regarding this interface is available
with the "C55 Hardware Interface Description"[1].
15.1 AT+CALA Set alarm time
Syntax
Test Command
AT+CALA=?
Read Command
AT+CALA?
Write Command
AT+CALA=[, [,
[, ]]]
Response(s)
+CALA: (list of supported s), (list of
supported s), (list of supported s)
OK
ERROR
+CME ERROR:
Response(s)
+ CALA: [, [, [, ]]]
OK
ERROR
+CME ERROR:
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0
GSM 07.07 ○ ●
Unsolicited Result Codes
URC 1
+CALA:
Indicates reminder message.
URC 2
^SYSSTART ALARM MODE
+CALA:
Indicates ME wake-up into Alarm mode. If autobauding is active
(at+ipr=0) the line "^SYSSTART ALARM MODE" does not
appear, but your individual message will be displayed.
Command Description
Test command returns supported array index values , alarm
types , and maximum length of the text to be
output.
Read command returns the list of current alarm settings in the ME.
The write command sets an alarm time in the ME. When the alarm is
timed out and executed the ME returns an Unsolicited Result Code
(URC) and the alarm time is reset to "00/01/01,00:00:00".
The alarm can adopt two functions, depending on whether or not you
switch the GSM engine off after setting the alarm:
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 273