C55/C55i AT COMMAND SET Description Preliminary - Falcom

C55/C55I AT COMMAND SET VERSION 1.00
Received signal level of the BCCH carrier (0..63). The indicated value
is composed of the measured value in dBm plus an offset. This is in
accordance with a formula specified in 3GPP TS 05.08
(num)
Coefficient for base station reselection, e.g. 30. In dedicated mode,
under certain conditions the parameter cannot be updated. In such
cases a '-' is presented.
Coefficient for base station reselection, e.g. 30. In dedicated mode,
under certain conditions the parameter cannot be updated. In such
cases a '-' is presented.
Note
•
To some extent, the cell monitoring commands AT^MONI, AT^MONP
and AT^SMONC cover the same parameters. The receiving level, for
example, can be queried with all three commands. Yet the resulting
values may be slightly different, even though obtained over a time
period of a few seconds. This is quite normal and nothing to worry
about, as the cell information is permanently updated.
^
7.6 AT MONI Monitor idle mode and dedicated mode
Syntax
(num)
Test Command
AT^MONI=?
Exec Command
AT^MONI
Response(s)
^MONI : (list of supported s)
OK
Response(s) See: 7.6.1
OK
Write Command Response(s) See: 7.6.1
AT^MONI=
OK
Reference(s) PIN ASC0
SIEMENS ○ ●
Command Description
The execute command can be used to retrieve the cell parameters of
the serving/dedicated cell on request.
The write command can be used to retrieve information of the
serving/dedicated cell automatically every seconds. To stop
the presentation type "AT" or "at".
Parameter Description
(num)
Display period in seconds
1...254
Notes
• The two header lines (see 7.6.1) are output after every ten data lines.
• The length of following output lines exceeds 80 characters.
Therefore a terminal program may draw a carriage return on a
screen. However, this is not part of the response.
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 136