C55/C55i AT COMMAND SET Description Preliminary - Falcom

C55/C55I AT COMMAND SET VERSION 1.00
0 Introduction
0.1 Scope of the document
This document presents the AT Command Set for the Falcom mobile phone
C55 Version 1.00.
More information is available at the Falcom website:
http://www.falcom.de/
0.2 Related documents
[1] C55/C55i user manual, Version 1.00
[2] ITU-T Recommendation V.24: List of definitions for interchange
circuits between data terminal equipment (DTE) and data circuitterminating
equipment (DCE)
[3] ITU-T Recommendation V.25ter: Serial asynchronous automatic
dialling and control [14] 3GPP TS 23.038 (GSM 03.38): Alphabets
and language specific information
[4] 3GPP TS 27.005 (GSM 07.05): Use of Data Terminal Equipment -
Data Circuit terminating Equipment (DTE-DCE) interface for Short
Message Service (SMS) and Cell Broadcast Service (CBS)
[5] 3GPP TS 27.007 (GSM 07.07): AT command set for User Equipment
(UE)
[6] 3GPP TS 27.060 (GSM 07.60): Mobile Station (MS) supporting
Packet Switched Services
[7] 3GPP TS 51.011 (GSM 11.11): Specification of the Subscriber
Identity Module - Mobile Equipment (SIM - ME) interface
0.3 Document conventions
Throughout the document, the GSM engines are referred to as ME (Mobile
Equipment), MS (Mobile Station), TA (Terminal Adapter), DCE (Data
Communication Equipment) or facsimile DCE (FAX modem, FAX board).
To control your GSM engine you can simply send AT commands via its
serial interface. The controlling device at the other end of the serial line is
referred to as TE (Terminal Equipment), DTE (Data Terminal Equipment)
or plainly 'the application' (probably running on an embedded system).
All abbreviations and acronyms used throughout this document are based on
the GSM specifications. For definitions please refer to TR 100 350 V7.0.0
(1999-08), (GSM 01.04, version 7.0.0 release 1998).
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 8