C55/C55i AT COMMAND SET Description Preliminary - Falcom

C55/C55I AT COMMAND SET VERSION 1.00
6.8 ATDL Redial last telephone number used
Syntax
Exec Command
ATDL[;]
Reference(s) PIN ASC0
V.25ter ● ●
Response(s)
If there is no last number or number is not valid:
+CME ERROR
If no dialtone (parameter ATX2 or ATX4):
NO DIALTONE
If busy (parameter setting ATX3 or ATX4):
BUSY
If connection cannot be set up:
NO CARRIER
If successfully connected and non-voice call (TA
switches to online data mode):
CONNECT
When TA returns to command mode after call
release:
OK
If successfully connected and voice call:
OK
Command Description
This command redials the last voice and data call number used in the
ATD command. If terminated with semicolon ";" ATDL dials the last
voice call number stored in the "LD" phone book. Otherwise, the last
dialed data or fax number will be used (not contained in the "LD"
phone book).
Notes
• This command may be aborted generally by receiving a character
during execution. Abortion is not possible during some states of
connection setup such as handshaking.
• Parameter "I" and "i" only if no *#-code is within the dial string.
6.9 ATH Disconnect existing connection
Syntax
Exec Command
ATH[]
Reference(s) PIN
V.25ter ○
Response(s)
OK
ASC0
Command Description
Disconnect existing call from command line by local TE and
terminate call.
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 108
●