C55/C55i AT COMMAND SET Description Preliminary - Falcom

C55/C55I AT COMMAND SET VERSION 1.00
4.3 AT ^ SPIC Display PIN counter
Syntax
Test Command
AT^SPIC=?
Read Command
AT^SPIC?
Exec Command
AT^SPIC
Write Command
AT^SPIC=
Response(s)
OK
Response(s)
^SPIC:
OK
Response(s)
^SPIC:
OK
Response(s)
^SPIC:
OK
Reference(s) PIN ASC0
SIEMENS ○ ●
Command Description
The read command returns an identification of the currently required
password, e.g. the PIN, PUK, PH-SIM PUK etc. The
returned by the execute command refers to this password. In case there
is no currently required password (the responses to "AT+CPIN?" and
"AT+CPIN2?" both read "READY"), the read command nevertheless
identifies the password to which the execute command response
refers.
The execute command returns the number of attempts still available
for entering the currently required password, e.g. the PIN, PUK, PH-
SIM PUK etc. To check whether or not you need to enter a password
use commands AT+CPIN? , Read command AT^SPIC? and AT+CPIN2?.
If the responses to "AT+CPIN?" and "AT+CPIN2?" both read "READY",
there is no currently required password, and the referrerof the execute
command "AT ^ SPIC" is explicitly undefined.
In these cases, the read command "AT ^ SPIC?" may be used to
determine, which password the response of the execute command
actually refers to. Also, the write command may be used in order to
retrieve the counter for a specific password.
The write command returns the number of attempts still available for
entering the password identified by , e.g. the PIN, PIN 2,
PH-SIM PIN etc.
Parameter Description
(num)
Number of attempts for the currently required password. This number
will be counted down after each failure.
(str)
Password for which the corresponding PIN counter is to be displayed
"SC" SIM PIN or SIM PUK. If the SIM PIN has been
deactivated after three failed attempts, the counter
for SIM PUK will be returned instead.
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 79