C55/C55i AT COMMAND SET Description Preliminary - Falcom

C55/C55I AT COMMAND SET VERSION 1.00
2 Status Control Commands
The AT commands described in this chapter allow the external application
to obtain various status information from the C55.
2.1 AT+CMER Mobile Equipment Event Reporting
This command controls details of the "+CIEV" URC presentation related to
AT^SIND and AT+CIND. If registered via these commands the URCs are sent
whenever a value of the related indicator changes. In addition, AT+CMER
controls "^SLCC" URCS related to AT^SLCC. For details refer to 6.1, AT^SLCC
and AT^SCFG, parameter . After AT+CMER has been switched on,
URCs for all registered indicators will be issued.
Syntax
Test Command
AT+CMER=?
Read Command
AT+CMER?
Write Command
AT+CMER=[[, [,
[, [, [,
[, ]]]]]]]
Response(s)
+CMER: (list of supported s), (list of
supported s), (list of supported s),
(list of supported s), (list of supported
s)
OK
Response(s)
+ CMER: , , , ,
OK
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0
GSM 07.07 ● ●
Unsolicited Result Code
+CIEV: ,
A value of an indicator has changed.
Command Description
The read command returns the URC presentation mode and
among others, the indicator event reporting status .
The write command enables and disables the presentation of "+CIEV:
, " URCs. refers to the name of a
"+CIEV" indicator and is the new value of this indicator.
All registered indicator events will be issued to the TE.
Parameter Description
(num)
0 (&F) Discard "+CIEV" and "^SLCC" URCS.
1 Discard "+CIEV" and "^SLCC" URCS when TA-TE link is
reserved, e.g. in online data mode. Otherwise they are
forwarded directly to the TE.
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 45