C55/C55i AT COMMAND SET Description Preliminary - Falcom

C55/C55I AT COMMAND SET VERSION 1.00
0.3.1 Quick reference table
Each AT command description includes a table similar to the example
shown below. The table is intended as a quick reference to indicate the
following functions:
PIN: Is the AT command PIN protected?
● Yes
○ No
◑ Usage is dependent on conditions specified for the
command, or not all command types are PIN protected
(for example write command PIN protected, read
command not).
Note: The table provided in the chapter 17.3 uses the same
symbols.
ASC0: Is the AT command supported on the provided physical serial
interface.
ASC0?
Example:
● Yes
○ No
PIN ASC0
○ ●
0.3.2 Superscript notation for parameters and values
Parameter option Meaning
(&W) Parameter value will be stored with at&w
(&V) Parameter value will be displayed with at&v
(^SNFW) Parameter value will be stored with at^snfw
(+CSCS) Parameter value has to be (is) coded according to current
setting of (see at+cscs for details)
Table 1.1: Symbols used to indicate the correlations with other commands
Value option Meaning
[x] Default value: if the parameter is omitted, the value 'x'
will be assumed
x (&F) Factory default value, will be restored to 'x' with at&f
x (P) Powerup default value of a parameter which is not stored
at power down
x (D) Delivery default value of a parameter which cannot be
restored automatically
Table 1.2: Symbols used to mark different types of default values of parameters
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 9