C55/C55i AT COMMAND SET Description Preliminary - Falcom
C55/C55i AT COMMAND SET Description Preliminary - Falcom
C55/C55i AT COMMAND SET Description Preliminary - Falcom
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>C55</strong>/<strong>C55</strong>I <strong>AT</strong> <strong>COMMAND</strong> <strong>SET</strong> VERSION 1.00<br />
of the calls in the list of current calls. Please refer to 6.1 and <strong>AT</strong>^SCFG<br />
for further information about the configuration of this URC.<br />
Event reporting can be enabled separately for each interface. Interface<br />
settings are saved with <strong>AT</strong>&W and can be displayed with <strong>AT</strong>&V.<br />
Additionally, the URC presentation mode for the interface must be<br />
configured with <strong>AT</strong>+CMER.<br />
Depending on the value of <strong>AT</strong>^SCFG setting , Indicator "^SLCC"<br />
will be issued (if configured with write command <strong>AT</strong>^SLCC and<br />
<strong>AT</strong>+CMER)<br />
� when a state transition ends in state "active" or in state<br />
"unknown" (if <strong>AT</strong>^SCFG setting ="restricted")<br />
� when any state transition (including transitions beginning or<br />
ending in state "unknown") occurs in the list of active calls, or<br />
when a traffic channel is established (if <strong>AT</strong>^SCFG setting<br />
="verbose").<br />
If multiple displays of identical list configurations occur, this happens<br />
because of short intermediate states of the list, that have already been<br />
overridden by new transitions and states. Thus, it is guaranteed that<br />
the configuration displayed is always the current configuration at the<br />
time of the last display.<br />
The list of active calls displayed with this URC will always be<br />
^<br />
terminated with an empty line preceded by prefix " SLCC:", in order<br />
to indicate the end of the list.<br />
Command <strong>Description</strong><br />
The read command returns an indication whether event reporting is<br />
active for the current interface.<br />
The exec command returns a list of current calls of ME. If command<br />
is successful, but no calls are available, no information response is<br />
sent to TE.<br />
Use the write command to activate or deactivate event reporting for<br />
URC "^SLCC". Event reporting can be enabled separately for each<br />
interface. Interface settings are saved with <strong>AT</strong>&W and can be displayed<br />
with <strong>AT</strong>&V.<br />
Parameter <strong>Description</strong><br />
(num)<br />
<br />
call identification number as described in GSM02.30 subclause<br />
4.5.5.1; this number can be used in <strong>AT</strong>+CHLD command operations<br />
(num)(&W)(&V)<br />
<br />
0 presentation of URC "^SLCC" disabled<br />
1 presentation of URC "^SLCC" enabled<br />
(num)<br />
<br />
0 mobile originated call (MOC)<br />
1 mobile terminated call (MTC)<br />
(num)<br />
<br />
state of the call<br />
0 active<br />
1 held<br />
2 dialing (MOC)<br />
3 alerting (MOC)<br />
4 incoming (MTC)<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 119