C55/C55i AT COMMAND SET Description Preliminary - Falcom

More documents

Recommendations

Info

C55/C55I AT COMMAND SET VERSION 1.00 6.8 ATDL Redial last telephone number used Syntax Exec Command ATDL[;] Reference(s) PIN ASC0 V.25ter ● ● Response(s) If there is no last number or number is not valid: +CME ERROR If no dialtone (parameter ATX2 or ATX4): NO DIALTONE If busy (parameter setting ATX3 or ATX4): BUSY If connection cannot be set up: NO CARRIER If successfully connected and non-voice call (TA switches to online data mode): CONNECT When TA returns to command mode after call release: OK If successfully connected and voice call: OK Command Description This command redials the last voice and data call number used in the ATD command. If terminated with semicolon ";" ATDL dials the last voice call number stored in the "LD" phone book. Otherwise, the last dialed data or fax number will be used (not contained in the "LD" phone book). Notes • This command may be aborted generally by receiving a character during execution. Abortion is not possible during some states of connection setup such as handshaking. • Parameter "I" and "i" only if no *#-code is within the dial string. 6.9 ATH Disconnect existing connection Syntax Exec Command ATH[] Reference(s) PIN V.25ter ○ Response(s) OK ASC0 Command Description Disconnect existing call from command line by local TE and terminate call. This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission. Page 108 ●
C55/C55I AT COMMAND SET VERSION 1.00 Parameter Description (num) [0] disconnect from line and terminate call Notes • OK is issued after circuit 109 (DCD) is turned off, if it was previously on. • ATH terminates every circuit switched call (voice, data or fax), even if it is issued via another interface. This behavior is in accordance with ITU-T V.25 ter; (07/97, "Hook control": "ATH is terminating any call in progress."). • ATH clears any active PDP context or terminates any existing PPP connection, but only if issued on the same interface where GPRS is used and if there is no pending network request for PDP context activation. It does not affect PDP contexts and PPP connections on other interfaces (see also chapter "ATH Manual rejection of a network request for PDP context activation"). 6.10 AT+CHUP Hang up call Syntax Test Command AT+CHUP=? Exec Command AT+CHUP Response(s) OK Response(s) OK ERROR +CME ERROR Reference(s) PIN ASC0 GSM 07.07 ● ● Command Description Cancels all active and held calls. Note • AT+CHUP implements the same behaviour as ATH. 6.11 ATS0 Set number of rings before automatically answering the call Syntax Read Command ATS0? Write Command ATS0= Response(s) OK Response(s) OK Reference(s) PIN ASC0 V.25ter ◑ ● This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission. Page 109
Page 1 and 2:
This document is available at HTTP:
Page 3 and 4:
C55/C55I AT COMMAND SET VERSION 1.0
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58: C55/C55I AT COMMAND SET VERSION 1.0
Page 89 and 90: XF55 AT COMMAND SET VERSION 1.00 4.
Page 107: C55/C55I AT COMMAND SET VERSION 1.0
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
Page 267 and 268:
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
Page 301 and 302:
show all

C55/C55i AT COMMAND SET Description Preliminary - Falcom

Create successful ePaper yourself

Delete template?

Save as template?