Programming Documents for Pre-K for SA - The City of San Antonio

B. The wiring blocks shall be fire retardant, molded plastic consisting of horizontal index strips
for terminating conductors. These index strips shall be marked with five colors on the high
teeth, separating the tip and ring of each pair, to establish pair location. A series of fanning
strips shall be located on each side of the block for dressing the cable pairs terminated on the
adjacent index strips. Clear label holders with the appropriate colored inserts shall be provided
with the wiring blocks. The insert labels shall contain vertical lines spaced on the basis of
circuit size (3-, 4-, or 5-pair) and shall not interfere with running, tracing or removing jumper
wire/patch cords.
C. The terminating block shall be able to accommodate over 500 repeated insertions without
incurring permanent deformation and it shall pass the reliability test of no more than one
contact failure in 10000 connections.
6.2.4.1 Acceptable Manufacturer’s
1. Panduit
6.2.5 Modular Face Plates
A. Provide faceplates for telecom outlets.
1. Unless otherwise indicated, provide stainless steel faceplates with brushed finish.
2. Faceplates shall have label holders.
B. Faceplates shall accommodate the following configurations
1. Single Gang Faceplates
(a) One, two, three or six modules
C. May be used with flat or angled modules
D. Available in white, gray, ivory, light ivory and stainless steel.
1. Submit color for approval prior to ordering
6.2.5.1 Acceptable Manufacturer’s
1. Panduit
6.2.6 Surface Mount Boxes
A. Surface mount boxes shall be available in one, two, four and six port configurations, with
modules to support UTP, fiber and coax.
B. Available in black, white, gray, ivory and light ivory.
6.2.6.1 Acceptable Manufacturer’s
1. Panduit
26