Programming Documents for Pre-K for SA - The City of San Antonio

7.2.5 Fiber Optic Connectors – Multimode
A. Provide LC type fiber optic connectors on multimode fiber optic cable with the following
minimum specifications:.
1. Insertion Loss of 0.2dB typical
2. Reflection of 0.2dB typical
3. Durability for 1000 rematings with less than 0.2db change
4. Provide beige boot on multimode connectors
7.2.5.1 Approved Manufacturer’s
1. Corning
2. Ortronics
3. Siemon
4. Systimax
7.2.6 Fiber Optic Termination Panels
A. Rack Mountable in standard EIA 19 inch equipment rack
B. Provide separate panels for multimode and single-mode fiber
7.2.6.1 Approved Manufacturer’s
1. Panduit
7.2.7 Multi-Pair Copper Riser Cable
A. Shielded 24 AWG multi-pair copper cables shall be used as the vertical riser cables. The
cable shall support voice, data and building service applications. The bending radius and
pulling strength requirements of all backbone cables shall be observed during handling and
installation. The multi-pair copper cables shall be riser rated and placed in conduit.
B. ARMM Shielded Non-Plenum Riser Cable
1. Shielded non-plenum riser cable shall consist of solid-copper conductors insulated with
expanded polyethylene covered by a PVC skin, be conformance tested to meet EIA/TIA
568A for Category 3 cables, be UL® and c (UL®) Listed as CMR. The core shall be
overlaid with a corrugated aluminum sheath, which is adhesively bonded to an outer
jacket of PVC plastic to form an ALVYN sheath.
2. The PVC sheath shall have improved frictional properties, allowing it to be pulled
through conduit without the use of lubricants.
3. The copper riser cable shall meet or exceed the electrical specifications listed below:
a. Average DC Resistance: 8.7 ohms/100m, maximum
b. Mutual Capacitance @1kHZ: 5.25 nF/100m, maximum
7.2.7.1 Approved Manufacturer’s
1. Superior Essex
31