sepam 20 user manual - Schneider Electric
sepam 20 user manual - Schneider Electric
sepam 20 user manual - Schneider Electric
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
6<br />
DE51675<br />
Installation LPCT type current sensors<br />
Test accessories<br />
6/<strong>20</strong><br />
Accessory connection principle<br />
DANGER<br />
HAZARD OF ELECTRIC SHOCK, ELECTRIC ARC OR BURNS<br />
b Only qualified personnel should install this equipment. Such work should be<br />
performed only after reading this entire set of instructions.<br />
b NEVER work alone.<br />
b Turn off all power supplying this equipment before working on or inside it.<br />
Consider all sources of power, including the possibility of backfeeding.<br />
b Always use a properly rated voltage sensing device to confirm that all power<br />
is off.<br />
Failure to follow these instructions will result in death or serious injury.<br />
1 LPCT sensor, equipped with a shielded cable fitted with a yellow RJ 45 plug which<br />
is plugged directly into the CCA670/CCA671 connector.<br />
2 Sepam protection unit.<br />
3 CCA670/CCA671 connector, LPCT voltage interface, with microswitch setting of<br />
rated current:<br />
b CCA670: lateral plugs, for Sepam series <strong>20</strong> and Sepam series 40<br />
b CCA671: radial plugs, for Sepam series 80.<br />
4 CCA613 remote test plug, flush-mounted on the front of the cubicle and equipped<br />
with a 3-meter (9.8 ft) cord to be plugged into the test plug of the CCA670/CCA671<br />
interface connector (9-pin sub-D).<br />
5 ACE917 injection adapter, to test the LPCT protection chain with a standard<br />
injection box.<br />
6 Standard injection box.<br />
PCRED301005EN - 06/<strong>20</strong>08