sepam 20 user manual - Schneider Electric

6
DE52153
DE51683
Installation MES114 modules
6/30
Description
L , M and K : 3 removable, lockable screw-type connectors
L : connectors for 4 relay outputs:
b O11: 1 control relay output
b O12 to O14: 3 annunciation relay outputs
M : connectors for 4 independent logic inputs I11 to I14
K
: connectors for 6 logic inputs:
b I21: 1 independent logic input
b I22 to I26: 5 common point logic inputs.
1 25-pin sub-D connector to connect the module to the base unit.
2 Voltage selector switch for MES114E and MES114F module inputs, to be set to:
b V DC for 10 DC voltage inputs (default setting)
b V AC for 10 AC voltage inputs.
3 Label to be filled in to indicate the chosen parameter setting for MES114E and
MES114F input voltages.
The parameter setting status can be accessed in the "Sepam Diagnosis" screen of
the SFT2841 software tool.
Parameter setting of the inputs for AC voltage (V AC setting) inhibits the "operating
time measurement" function.
Assembly
1. Insert the 2 pins on the MES module into the slots 1 on the base unit.
2. Flatten the module up against the base unit to plug it into the connector 2.
3. Tighten the mounting screw 3.
PCRED301005EN - 06/2008