sepam 20 user manual - Schneider Electric

DE80292
DE50564
Installation LPCT type current sensors
Test accessories
10.24
Accessory connection principle
PCRED301005EN - 06/2008
CAUTION
6.70
HAZARD OF CUTS
Trim the edges of the cut-out plates to remove any
jagged edges.
Failure to follow this instruction can cause
serious injury.
2.75
ACE917 injection adapter
Function
The ACE917 adapter is used to test the protection chain with a standard injection
box, when Sepam is connected to LPCT sensors.
The ACE917 adapter is inserted between:
b The standard injection box
b The LPCT test plug:
v integrated in the Sepam CCA670/CCA671 interface connector
v or transferred by means of the CCA613 accessory.
The following are supplied with the ACE917 injection adapter:
b Power supply cord
b 3-meter (9.8 ft) cord to connect the ACE917 to the LPCT test plug on
CCA670/CCA671 or CCA613.
DE80045
DE80047
Characteristics
Power supply 115/230 V AC
Protection by time-delayed fuse 5 mm x 20 mm (0.2 x 0.79 in ) 0.25 A rating
CCA613 remote test plug
Function
The CCA613 test plug, flush-mounted on the front of the cubicle, is equipped with a
3-meter (9.8 ft) cord to transfer data from the test plug integrated in the CCA670/
CCA671 interface connector on the rear panel of Sepam.
Dimensions
mm
in
Front view with cover lifted. Right side view.
mm
in
Cut-out.
44
1.73
46
1.81
67,5
2.66
69
2.72
DE80117
mm
in
Lug
Wire
13 50
0.51 1.97
80
3.15
67,5
2.66
6/21
6