1997 QUT Handbook

Standard Credit Points/Full-Time Semester: 48
Course Coordinator: Dr Andy Tan
Special Course Requirements
A candidate for the degree of Bachelor of Technology (Mechanical) must obtain at least 50 days of industrial
experience, with a minimum of 25 days in an engineering environment, approved by the Course Coordinator.
Candidates must, not later than the fourth week of semester immediately following each period of industrial
experience, submit to the Faculty Office, a report in the required format, describing the work carried out
during the period of experience and including an Industrial Experience Record Form signed by the employer.
Industrial Experience Record Forms are available from outside the FacultyOffice, Room 1006, ITE Building,
Gardens Point campus.
Students should not formally enrol in industrial employment.
Students will be permitted to articulate to the Bachelor of Engineering (Mechanical) in mid-course only
after the completion of 48 credit points with a GPA (Grade Point Average) of 5.5 or above in the Bachelor
of Technology (Mechanical).
Full-Time Course Structure Credit Points Contact Hrs/Wk
DIRECT ENTRY
Year 1, Semester 1
BNB004 Technology and Society 8 3
CEB184 Engineering Mechanics 1 8 3
CHB002 Introduction to Engineering Chemistry 11 (2) 1
EEB101 Circuits and Measurements 8 3
MAB103 Introductory Engineering Mathematics 8 3
PHB001 Introductory Physics 8 3
MEB181 Engineering Communication 8 4
Year 1, Semester 2
EEB209 Electrical Engineering 2M 8 3
MAB187 Engineering Mathematics 1A 8 3
MEB134 Materials 1 8 3
MEB175 Manufacturing Practice 1 8 3
MEB612 Mechanical Measurement 8 3
PHB134 Engineering Physics 1B 8 3
Year 2, Semester 1
MAB188 Engineering Mathematics 1B 8 3
MEB275 Manufacturing Practice 2 8 3
MEB283 Computer Aided Design & Drafting 8 4
MEB352 Thermodynamics 1 8 4
MEB363 Fluids 1 8 4
MGB004 Managing People at Work 8 2
Year 2, Semester 2
MAB185 Introduction to Statistics 8 3
MEB111 Dynamics 8 3
MEB213 Mechanics of Solids 8 4
MEB232 Materials Technology 1 8 3
MEB282 Design 1 8 4
MEB473 Manufacturing Engineering 1 8 4
Year 3, Semester 1
MEB314 Mechanics 1 8 4
MEB355 Thermofluids 8 3
MEB381 Design 2 8 3
MEB501/1 Project 8 3
MEB572 Manufacturing Engineering 2 8 4
Elective Unit (Select from List A) 8 3
11 CHB002 Introduction to Engineering Chemistry is to be taken by those students not obtaining a SA in Year 12 Chemistry.
All other students must apply for an exemption from this unit.
315
BUILT ENVIRONMENT & ENGINEERING