SCT Banner Student / Release Guide / 7.0

Section 13 Problem ResolutionsCAPP ModuleSMASARA (#80729)The debug message “call set default” no longer appears in the autohint for the ID andName fields. Resolved in Release 7.0.SMIAOUT (#94517)The Edit button that allows you to navigate to a rule-with-rule in the Detail Area RuleRequirement window is now enabled. Resolved in Release 7.0.ReportsSMRBCMP (#93908)Previously, when run in batch using a population selection, compliance may haveaborted as a result of a unique constraint error in the Split Courses Temporary Table(SMTSPLT). This issue has been resolved. Resolved in Release 7.0.SMRBCMP (#72548)Previously, when you requested that graduation date and admit term be printed ona compliance report, these items were not displayed when the request was processedin batch using a population selection and pointing the curriculum source to theGeneral Student record. This issue has been resolved.However, this issue was also reported to happen when a new request was copied fromone that had already been processed. It is explained in the documentation that thisbehavior is expected, and therefore, in this situation the issue was not addressed asa defect.Resolved in Release 6.2.SMRBCMP (#80499)Previously, when the Batch Compliance Process was run with a population selectionand the Curriculum Source parameter was set to use the General Student record,the hardcopy output indicated: “Curr Srce : Degree #0”. This issue has been resolved.Resolved in Release 6.2.SMRBCMP (#81576)Previously, when batch compliance was run and the Send to Advisors parameter wasset to Y, the message “***WARNING - No Address ***” would print below the advisor'sname, even though the documentation indicates that no advisor address would beprinted. This situation has been resolved. Resolved in Release 6.2.SMRBCMP (#80498)Previously, when the Batch Compliance Process was run in Population Selectionmode, if the Send to Advisors parameter was left null, no output was produced. Now,if this parameter is left null, the process will use the default value of N.Also, in order to make the process more user friendly, the following changes havebeen made to the parameter definitions for the process:January 2005 Student Release 7.0Confidential Release Guide 391