DS7200V2-EXP - Simon Technologies

DS7200V2-EXP | Installation Guide | 3. Control Panel Programming EN | 102Remote Programming Callback Number Alternate Communication Options• Address: 3538• Default: 0• Selections:- 0 = No Alternate Communication- 1 = Enable Alternate CommunicationIf an IP address is entered into the Remote Programming Callback Number addresses (Addresses 0181-0212),RPS can be used to program the control panel over an Ethernet network.Select “1” if an IP address is entered into the Remote Programming Callback Number addresses.Alternate Communication Wait Time• Address:- IP Address 1, Destination 1: 3507 to 3509- IP Address 2, Destination 1: 3515 to 3517- IP Address 1, Destination 2: 3523 to 3525- IP Address 2, Destination 2: 3531 to 3533• Default: 0, 1, 3• Selections: 0 to 1665 secUse this parameter to define how long the DX4020 waits before attempting to send additional reports to the ARC.This parameter uses three addresses for each routing destination. In the first address, enter the 100’s value (thisvalue is multiplied by 100). In the second address, enter the 10’s value (this value is multiplied by 10). In the thirdaddress, enter the 1’s value (the 100’s and 10’s values are added to the 1’s value).The following example shows how to get an alternate communication wait time of 555 sec for IP Address 1,Destination 1:[5 x 100] + [5 x 10] + 5 = 555 secAddress 3507 EntryAddress 3508 EntryAddress 3509 EntryIf the “Use ARC Acks” option is enabled and the alternate communication wait time is less than 5 sec, aminimum of 5 sec is automatically used.You can enter a value between 0 and 15 for each alternate communication wait time address.Bosch Security Systems, Inc. | 2/09 | 4998153893-03