DS7200V2-EXP - Simon Technologies

DS7200V2-EXP | Installation Guide | 3. Control Panel Programming EN | 71Area Option, User #• Address: See Table 10• Default:- User 1:- DS7240V2: 15 (Areas 1 to 4)- DS7220V2: 3 (Areas 1 and 2)- Users 2 to 32: 0 (Not assigned to an area)• Selections: 0 to 15Enter This Data Digit to Select OptionsUser Area Options 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15Not Assigned to an Area •Assigned to Area 1 • • • • • • • •Assigned to Area 2 • • • • • • • •Assigned to Area 3 • • • • • • • •Assigned to Area 4 • • • • • • • •Assigning PINs to multiple areas allows users to view and operate multiple areas from a single keypad.RF ID for KeyfobYou must exit control panel programming in order to enter the RF ID code. Add RF ID codes after you completeyour programming session. See Adding RF ID Codes on page 41 for complete instructions.3.4.3 KeypadsWired Keypads 1 to 8 are fixed at Data Bus Addresses 1 to 8. See Keypad Addressing on page 14 for moreinformation. All keypads (and other Data Bus devices) are fully supervised. Supervision reports, such as missingand tamper reports, follow the System Status Report routing.Keypad # Options• Address:- Keypad 1: 0678- Keypad 2: 0680- Keypad 3: 0682- Keypad 4: 0684- Keypad 5: 0686- Keypad 6: 0688- Keypad 7: 0690- Keypad 8: 0692• Default: 7• Selections: 0 to 15Enter This Data Digit to Select OptionsKeypad Options 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15No Keypad Options •Beep Keypad on System Trouble • • • • • • • •Enable Exit Tone • • • • • • • •Enable Area Display (DS7446KP Keypad) • • • • • • • •Don’t Show Zone Status on Keypads • • • • • • • •Bosch Security Systems, Inc. | 2/09 | 4998153893-03