DS7200V2-EXP - Simon Technologies

DS7200V2-EXP | Installation Guide | 2. System Installation and Setup EN | 23Figure 28: Optional DX2010 Mounting Locations125 6Connect the control panel’s Data and Aux Powerterminals to the DX2010 as shown in Figure 29.If the DX2010’s Aux Output (“+Out-“terminals) is used as an auxiliary powersource, the DX2010’s “R” and “B” wiresmust be “home-run” to either the controlpanel or to an available power supply. Donot use a daisy-chain wire configuration.Figure 29: DX2010 to Control Panel Wiring2361- Control panel board location2- DX2010 optional mounting locationUp to five DX2014 modules can be connected to theDS7240V2 (up to 2 on a DS7220V2). See Figure 29 forwiring details.2.6.3 DX2010 WiringDo not use twisted pair or shielded cable when wiringthe DX2010.See the following tables for Data Bus wire lengthrequirements.Table 5: DX2010 to Control Panel Wire LengthAux OutputNot UsedAux OutputUsedAux OutputUsed or NotUsedPowerSourceControlPanelExternalPowerSupply08 mm(#22 AWG)305 m(1007.7 ft)30 m(98.4 ft)305 m(1007.7 ft)1.2 mm(#18AWG)610 m(2001 ft)76 m(249.3 ft)610 m(2001 ft)1GR B Y+OUT- TMPR 1 COM4BATT+BATT-1- DX2010 module2- Green (G) data wire3- Yellow (Y) data wire4- Black (-) wire5- Red (+) wire6- Control panel boardYou can use either one of the Aux Power (-) terminalsand either one of the 12 VDC (+) terminals whenconnecting devices to the control panel.5Table 6: DX2010 to External Power Supply WireLengthAux Output NotUsedAux Output Used08 mm(#22 AWG)305 m(1007.7 ft)30 m(98.4 ft)1.2 mm(#18 AWG)610 m(2001 ft)76 m (249.3 ft)Bosch Security Systems, Inc. | 2/09 | 4998153893-03