DS7200V2-EXP - Simon Technologies

DS7200V2-EXP | Installation Guide | 3. Control Panel Programming EN | 68User Tamper Retry Count• Address: 0381• Default: 4 (4 attempts)• Selections:- 0 = User Retry Count Disabled- 1 to 15 = Number of attempts allowed before a User Tamper event occursEnter zero (0) to disable this parameter. The control panel creates a User Tamper event when a user enters aninvalid PIN the number of times programmed in this parameter.For example, “5” is entered in this parameter. When an invalid PIN is entered five times, a User Tamper eventoccurs.User Tamper Lockout Time• Address: 0382• Default: 1 (1 minute)• Selections: 0 to 15 (min.)This parameter determines how long a keypad is locked out when a User Tamper event occurs (selections are inmin.).Installer PIN• Address: 0383 to 0389• Default: 9876543• Selections: 0 to 9Do not use digits 10-15 when creating the Installer PIN or User PIN. Entering these digits makes thePIN unusable and locks the installer out of the control panel.The Installer PIN length is the same as all other system PINs (see PIN Length on page 67).The default PIN length is 4 digits, which makes the Installer PIN 4 digits in length. For example, if the InstallerPIN is 7654321 and the PIN length is set to 4 digits, the Installer PIN changes to 7654.The Installer PIN cannot disarm the system, but it can access all other functions.The Installer PIN reports as User 0.If the Installer PIN is left at its factory default, the control panel generates a System Trouble event ifenabled in the Date Format and Enable PIN Trouble parameter (see the DS7200V2 ExpertProgramming Guide (P/N: 4998153891). Make sure to change the default value. This event is LocalOnly and is stored in the history buffer.The Enable PIN Trouble option is disabled by default.Bosch Security Systems, Inc. | 2/09 | 4998153893-03