DS7200V2-EXP - Simon Technologies

DS7200V2-EXP | Installation Guide | 3. Control Panel Programming EN | 643.3 Area Wide ParametersThe parameters in this section configure the control panel’s areas. Each area has 16 characters of programmabletext for an area name and 16 characters of programmable area idle text, which appear on the text keypad display.The DS7240V2 supports up to four areas. The DS7220V2 supports up to two areas.All control panel text is programmed from the text keypad in a special text-programming mode. See Text EntryAddresses on page 46 for text programming instructions.Area # Account Number• Address/Default: See Table 26• Selections: 0 to 15 (see Table 27)Table 26: Account Number Addresses/DefaultsAreaAccount # for RoutingDestination 1Account # for RoutingDestination 2Default Account #(for both destinations)1 Address 0276 to 0281 Address 0286 to 0291 10, 10, 10, 10, 0, 02 Address 0298 to 0303 Address 0308 to 0313 10, 10, 10, 10, 0, 03 (DS7240V2 only) Address 0320 to 0325 Address 0330 to 0335 10, 10, 10, 10, 0, 04 (DS7240V2 only) Address 0342 to 0347 Address 0352 to 0357 10, 10, 10, 10, 0, 0Table 27: Account Number Entry SelectionsFor this Selection Press this Key For this Selection Press this Key0 10 8 81 1 9 92 2 B 113 3 C 124 4 D 135 5 E 146 6 F 157 7 Terminate 0Each area uses the account number entered here to report to the ARC receiver. Different account numbers can beprogrammed for two routing destinations. See Routing Destinations on page 49 for a complete description of howthe control panel directs reports to the routing destinations.Account numbers can contain up to six (6) digits. If less than four digits are entered, the control panel adds zerosto the end to make a four-digit account number.The control panel automatically truncates the account number to the maximum length supported by that format.See Control Panel Events and Reporting Formats on page 107 for a complete description of the reporting formatsavailable to the control panel.One account number digit occupies each address. Use a zero (0) to terminate the account number entry if it is lessthan six digits in length.For example, to set an account number of 1234, enter 1 2 3 4 0 (0 = Terminate).Use “10” ([1][0] from the keypad) to enter “0.” Use “0” to terminate the account number.Bosch Security Systems, Inc. | 2/09 | 4998153893-03