DS7200V2-EXP - Simon Technologies

DS7200V2-EXP | Installation Guide | 3. Control Panel Programming EN | 613.2.6 Global Open/Close OptionsArming Options 1• Address: 0258• Default: 0• Selections: 0 to 7Enter This Data Digit to Select OptionsArming Options 1 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15No Options Enabled •Enable All On-No Exit • • • •Answering Machine Bypass only when All/Perimeter OnlyOn• • • •Remote Arming with Telephone, Area 1 • • • •Reserved• Enable All On-No Exit: If this option is enabled and the system is turned All On and no Entry/Exit zonesare faulted during Exit Delay, the system automatically shifts to Perimeter Only. Perimeter Only (not All On)appears in the log and reports. This option can only be used if the control panel is armed with delay. Thisoption does not apply when arming with keyswitches or RF keyfobs.• Answering Machine Bypass Only When All On/Perimeter Only On: If this option is enabled, theAnswering Machine Bypass function is activated at RPS Answer Ring Count, Answering Machine Bypass parameter(see page 55). If activated there, this option can be used to restrict its function so that it only operates whenthe system is All On or Perimeter Only On. The system does not answer if disarmed.• Remote Arming with Telephone, Area 1: If enabled, this option controls the built-in telephone armingfeature for Area 1. When enabled, the control panel answers the phone on the ring count for remoteprogramming. The following occurs when the control panel answers the phone:- If the control panel is All On or Perimeter Only On, it sounds three beeps and starts the handshake tonefor remote programming.- If the control panel is Off, it sounds one short beep, waits approximately three sec and then starts thehandshake tone for remote programming (one long beep). Press and hold [5] for two sec immediatelyafter the first short arming beep and before the handshake tone begins.If arming from a cell phone, quickly press [5] three times. If pressing and holding [5] for two sec from ahouse (landline) phone does not produce a tone long enough to arm Area 1, retry by quickly pressing [5]three times.- The control panel arms if it detects a [5] key press from the telephone (All On with Delay, faulted zonesare force-armed like keyswitch arming). The control panel sounds three beeps (new armed state) and thenhangs up.You cannot use a telephone to disarm the control panel.Bosch Security Systems, Inc. | 2/09 | 4998153893-03