12.07.2015 Views

DS7200V2-EXP - Simon Technologies

DS7200V2-EXP - Simon Technologies

DS7200V2-EXP - Simon Technologies

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

<strong>DS7200V2</strong>-<strong>EXP</strong> | Installation Guide | 3. Control Panel Programming EN | 493.2 Panel Wide Parameters3.2.1 Routing DestinationsThe control panel has two routing destinations for the routing of reports. The control panel routes by zone andreport group to the destinations. For example, you can send alarm reports for one zone to Destination 1 and foranother zone to Destination 2. You can program two phone numbers (or IP addresses) for each destination.Communication Fail events are by destinations and not by phone number/IP address.For a description of the routing/dialing process, see Communication Attempt Tables on page 121.Phone Number 1 (2) for Destination 1 (2)• Address Range:- Phone 1, Destination 1: 0000 to 0031- Phone 2, Destination 1: 0032 to 0063- Phone 1, Destination 2: 0066 to 0097- Phone 2, Destination 2: 0098 to 0129• Default: All zeroes (0)• Selections: 0 to 14 (see Table 22)Table 22: Phone Number Entry SelectionsDigit to be Dialed Enter at Keypad Digit to be Dialed Enter at Keypad1 [1] 9 [9]2 [2] 0 [1][0]3 [3] * [1][1]4 [4] # [1][2]5 [5] P (4-second pause) [1][3]6 [6] F (on-hook, pause, off-hook) [1][4]7 [7] Reserved [1][5]8 [8] T (Terminate) [0]When entering phone numbers, use “10” ([1][0] from the keypad) to dial “0”; enter “0” to terminate thephone number. This does not apply when entering an IP address.Terminate telephone numbers with less than 32 digits by entering a zero (0) in the Address after thelast digit to be dialed.The control panel can dial up to 32 digits per phone number. Each digit occupies one address. If less than 32digits are entered into the Phone Number Address range, the control panel dials digits until it reaches a terminator(0).IP addresses can be entered into these addresses for network communication. See Network Communication on page100 for more information. Firmware revision 2.10 or greater is required for network communication.See Area # Account Number on page 64 for instructions on entering an account number.Bosch Security Systems, Inc. | 2/09 | 4998153893-03

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!