DS7200V2-EXP - Simon Technologies

DS7200V2-EXP | Installation Guide | 3. Control Panel Programming EN | 91Table 34: Output Function Types (continued)Digit 1 Digit 2 Function Type Description5 1 Trouble Zone Function 1to5 15 Trouble Zone Function 15These 15 output functions activate for troubles on any zone assigned tothe specified Zone Function. They reset when none of the zones assignedto the specified Zone Function are in trouble.6 0 Change Outputs Activated/deactivated by Change Outputs function ([#][5][4]).6 1 Follow PIN 1to6 15 Follow PIN 157 0 Follow PIN 16to7 15 Follow PIN 318 0 Follow PIN 32These output functions activate when the specified PIN is entered.Output Function Type 7, 12 follows User 28, which can be programmedas the Guard Code User (see page 77).These output types are event-driven. See Mode (Steady, Pulse, OneShot), Output ## on page 92 for more information.PIN area assignments are ignored when these output functions areselected.8 1 Sked Only This output type is only available for Outputs 1 to 15. Activated by Skeds.See Assign (Area or Output), Sked # on page 96 for more information.8 2 Change Outputs Activated/deactivated by Change Outputs function ([#][5][4]).8 3 Always On Output is always activated.8 4 Verified Alarm Activates when the requirements for a verified alarm are met. Resetswhen a PIN is entered.8 5 Unverified Alarm Activates on any non-24-hr alarm, 24-hr tamper or 24-hr burglary alarm.Resets when the verified alarm timer resets or when a PIN is entered.8 6 Tamper Activates on any tamper condition. Resets when the tamper conditionrestores.8 7 Bypass Activates when any input is bypassed. Resets when all input bypassesare cleared.8 8 Enhanced Siren Activates on Exit Delay, Entry Delay, Chime, Alarm, Tamper, Trouble, orBad Set. Resets at the end of bell time or when a PIN is entered.8 9 Alarm Cancel Activates on a cancelled alarm. Resets when alarm is cleared.8 10 RF Transmitter Missing Activates when any RF transmitter is missing. Restores by pressing[System Reset].8 11 RF Transmitter Low Battery Activates when any RF transmitter is reporting a low battery. Resets bypressing [System Reset].8 12 RF Receiver Jamming Activates when RF Jamming is present. Resets by pressing [SystemReset].8 13 Fire Alarm Only Activates on Fire Alarm only. PIN resets. Does not pulse in TemporalCode 3 format.8 14 Personal Alarm Activates when one of its assigned areas is set to Personal Alarm. Resetsby entering a valid user PIN, pressing the [System Reset] key, or by RPS(System Reset command). Activates on any of the following conditions:(1) If a Duress User PIN is entered (2) If an Emergency key is active in anarea and “Activate Panic Alarm Response” and “Alarm Output” areenabled for the key (3) If a RF keyfob reports a Panic alarm (4) If a zoneconfigured for 24-hr Visible Panic (Zone Function Type 6) goes intoalarm, or (5) Certain [Q] button configurations. See the DS7200V2Expert Programming Guide (P/N: 4998153891) for [Q] buttoninformation.8 15 [Q] Button Output activates when the [Q] button is pressed on a RF keyfob. ForSteady or Pulse modes, [System Reset] resets. This output function typeis event-driven. See Mode (Steady, Pulse, One Shot), Output ## onpage 92 for more information.Bosch Security Systems, Inc. | 2/09 | 4998153893-03