DS7200V2-EXP - Simon Technologies

DS7200V2-EXP | Installation Guide | 3. Control Panel Programming EN | 593.2.5 TestsAutomatic Test {137} Report Options• Address: 0249• Default: 0• Selections: 0 to 4, 8 to 12Enter This Data Digit to Select OptionsAutomatic Test Report Options 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15No Automatic Test Report Options •Test Report Only if System is Armed • • • •Defer Test Report if Other Report Sent in TestInterval• • • •Test Reports for All Areas (else Area 1 only) • •Call RPS at Test Time (after Test Report) • • • • •Use these options to configure the Automatic Test {137} report. If “Call RPS at Test Time” is enabled, a variety oftasks could be accomplished at this time, including downloading the log to the ARC.• Test Report Only if System is Armed: This option sends a test report only if the system is armed.• Defer Test Report if Other Report Sent in Test Interval: If another report is sent during the test interval,this option defers the test report until the end of the test interval.• Test Reports for All Areas (else Area 1 only): If selected, this option generates a test report for all enabledareas. For the DS7240V2, this option applies to Areas 1 to 4. For the DS7220V2, this option applies to Areas1 and 2.• Call RPS at Test Time (After Test Report): If selected, this option calls RPS at test time after the systemsends the test report. The Remote Programming Call Back Phone Number should be programmed. SeeRemote Programming Call Back Number on page 54 for more information.Automatic Test {137} Report Time• Address: 0250 to 0253• Default: 0000 (Test reports disabled)• Selections: 0 to 9Enter the time of day for the Automatic Test. Use 24-hour format (HHMM) where midnight is 2400, noon is 1200,and 12:01 AM is 0001. Enter one digit in each address so that Addresses 0250 and 0251 are the hour, and 0252and 0253 are the minute. An entry of 0000 (the default setting) disables the Automatic Test {137} report.Bosch Security Systems, Inc. | 2/09 | 4998153893-03